Periodic Water Heater Maintenance

In: Home & Family

10 Sep 2013

Prolonging the life of your water heater is important, especially if you want a continuous supply of hot water running in your pipes. Some homeowners may find this a daunting task since it can take too much of their time. Not to worry, you can always ask help from a specialist whenever it’s time to inspect your water heater.

If not handled properly, water heater can convert into dangerous heating devices. Before carrying out repairs, it is important to take safety precautions to avoid unfortunate accidents. Shut down the heating source of the unit together with the cold water supply valve. Mop the water puddles as soon as you notice them and drain the entire tank to stop the leaks temporarily.

If the water is starting to discolor and smell bad, it is safe to assume that your anode rod has completely deteriorated. This sacrificial rod should always be in good condition since it attracts all charged water molecules inside, protecting it from rust and corrosion. Buy a replacement once it measures less than of an inch.

If sediments continue to build up, simply drain and flush the heater to remove the filth inside the tank. This should be done on a semi-annual basis, especially if you have highly corrosive water. Make sure to run the other end of the hose to a secure drainage location to avoid scalding burns. If it’s not too much of an inconvenience, you can turn off the heater the night before draining it to allow water to cool down.

Check your plumbing connections if your water heater is leaking from the pipes. Adjust the loosely joined fittings with a wrench without over tightening them. Protect other areas of the tank from rusting by replacing pipes that are badly damaged. Secure the fittings into place by wrapping a Teflon tape around the threading.

Your water heater comes with a relief valve that releases excessive pressure inside the tank. This valve should be working at all times to protect your tank from overheating or blowing up. You can check the water flow by lifting and releasing its lever. Replace the relief valve if water continues to drip.

You can lower the temperature between 120 to 130 degrees Fahrenheit to prevent pressure from building up inside the tank. Once you have a stable temperature, there is no need to adjust the thermostat settings. Do not set the temperature too high to protect the members of your family from scalding burns.

Sustain your tank’s efficiency and prevent it from corroding by performing regular water heater maintenance. You are left with no option but to maintain your heating system if you are not financially ready to buy a replacement.

Learn more about water heater repair tips . Stop by Carol Richardson’s site where you can find out all about water heater maintenance and how it can benefit you.

Comment Form